MTB FRAME PROTECTORS
Application Instructions
1
Wipe and clean all surfaces thoroughly with an appropriate isopropyl prepping agent (eg: methylated Spirits).
Allow to dry.
2
Lay out each of your new graphic prints with corresponding frame section as indicated. Take care to perfectly align the graphic on the frame.
3
Peel a small amount of the backing paper from the corner of the graphic and apply to frame by pressing firmly.
RECOMMENDED: Use an application glove or squeegee.
4
Gradually remove small sections of the backing paper as you work and apply graphic to frame using a back-and-forth motion.
If you find a bubble/crease/ripple beginning to develop, lift the sticker slightly and continue with the back-and-forth motion. Using heat will assist the graphic to conform.
5
Applying heat from a heat gun/hair dryer will make the graphic more flexible and allow you to manoeuvre it better.
WARNING: Ensure you apply heat gradually as overheating will result in damaging the graphics.
6
Once you are satisfied with your application, we recommend you heat all the graphics, ensuring all air has been removed from under the graphic and to assist in better adhesive.
7
FOR BEST RESULTS: Allow 72hrs for the graphics to adhere/bond correctly before riding or washing.
During this time continue to check the graphics, if necessary, apply heat and press down on any areas lifting.
8
Failure to follow any of these instructions properly may result in, imperfect decals and a short lifespan of your new graphics.
